Often a design calls for a twist of given length, sometimes a tight or loose twist. To determine the length to cut the wire is important. The gauge of the wire as well as the number of twists the wire is given will determine the length of the finished piece.
When round wire is used, two or more lengths are necessary for the twist. A rope-like effect may be obtained by twisting a single length of flat or square wire. All wire should be annealed.

Twisting wire 18 gauge or lighter

Measure the amount needed for the twist. Loop the wire length in the center, and insert the two loose ends through the hole in the spool. Hold the ends in the jaws of a table vise. Insert a small steel rod through the loop of wire, and pull the wire taut. Hold the spool firmly against the rod. Turn the rod to twist the wire.

Twisting wire 16 gauge or heavier

Hold the looped end of the wire in the jaws of the hand vise. Clamp the loose end in the jaws of the table vise. Turn the hand vise to twist the wire.

To determine the length

In cutting the wire for a definite length of finished twist, the following examples have been given of two round wires of different gauges and lengths.

18 gauge, 26 inches, twisted 50 times, gives 11 1/8, inches
18 gauge, 26 inches, twisted 75 times, gives 9 5/8 inches
18 gauge, 14 inches, twisted 50 times, gives 5 1/4 inches
20 gauge, 14 inches, twisted 50 times, gives 4.7/8^ inches

Twisting fine wire

Twisting heavier wire. The wire is annealed. It is held taut while being twisted but will break if it is twisted too tightly.

Technorati Tags: jewelry wire, Make Jewelry, wire jewelry, wire twisting