Two identical stones with flat base.

Apply liquid cement to the base of each.

Bind together until dry.

22 gauge silver wire

Measure the circumference of the stone.

Cut a length of wire 1 inch longer than measured.

Lay the wire in the groove between the stones.

Twist the wires together, and make a loop.

Mounting a stone with hooks

File a 1/16 inch groove the length of a soft stone.

Make a notch on each end of the groove.

1/16 inch half round silver wire – Use enough  for the length  of the stone and the
hooks.

Shape the wire as shown.

Cement the wire into the groove.

Bend the ends to meet the stone.

Making Jewelry

Technorati Tags: bind stone, pendants

26 gauge silver sheet

Cut and dome a 1/4 inch disk A. The size of the disk depends upon the stone B.

Place the dome on a lead block with the cup up. Punch a hole in the center C. File the rough edge of the hole D.

22 gauge silver wire

Make a loop in a short length of wire E.

Insert the ends through the hole in the dome F.

Spread the wire against the sides of the cup G.

Bend the dome slightly oval to fit the stone.

Insert adhesive tape in the loop.

Apply liquid cement inside the cup.

Bind the dome to the stone to form a cap H.

Remove the tape when the cement is dry.

Technorati Tags: capping stone, stone pendant

ALLIGATOR CLIPS FOR THIRD HAND

Great for jewelry making.  Hold the piece in place while your work on it.
Priced per piece.

Buy/More Info

Technorati Tags: alligator clip, Make Jewelry